Corsair Lighting Node Pro Arduino

Guide to make a Arduino RGB controller

For a DIY custom solution utilizing the Corsair Lighting Protocol which emulates a Corsair Lighting Node Pro the following hardware will need to be purchased:

Required Parts

Arduino ATmega32U4 based module board the brains of the operation. Molex Connector used as Channel 1 & 2 on the LNP (You will need two) 5V Molex Power or 5V SATA Power to power your new LNP or see the additional recommendations for providing power below Internal USB Cable to connect your LNP to your motherboard header 22AWG Wire If you need wire get this Heat shrink tubing to make sure your soldered wires do not short against anything

ToolsWire Stripper Soldering Iron Kit Soldering Mat

Additional Recommendations for providing power to the DIY LNP

DC Voltage Regulator Buck Converter DC 5V 15A

One of these is required for the 12V input and will be modified for itMolex Power Splitter Cable SATA Power Y-Splitter Cable EPS 12V cable extension